What should I do if the plasticine packaging machine fails?

As we all know, plasticine is a common children's toy in our life, and the sales volume is very large. Manufacturers basically choose plasticine packaging machines for unified packaging and sales, which is convenient and efficient, and can get better output returns. So, as you all know, plasticine packaging machines will encounter any failures in the packaging process? How can we solve them? Today, the editor of Foshan Jiayite, I will take you to know about it.

(China Clay Packaging Machine Supplier)

1. The temperature is too high and the speed is too slow. When the heat resistance of the outer layer of the coating is poor, there will be traces of scorch wrinkles on the seal. The repair method is to increase the speed, reduce the temperature, and replace the film material.

2. The knife seat is too high or too low, the packaging speed is too fast, when the push rod and the cutter are not synchronized, the cutter will cut on the product. The maintenance method is to reduce the packaging speed and adjust the height of the end sealing parts, so that the center of the sealing knife is in The middle position of the product height.

3. The color of the film color code is too light, the film drive is slippery, and the cutting position will deviate from the color code when the color code tracking is not turned on. At this time, the maintenance method is to refer to the instructions of the packaging machine book, adjust its sensitivity; in the man-machine dialogue interface, switch the tracking mode to "tracking cut".

4. The solid-state circuit breaker is burned out, the temperature control meter is damaged, and the thermometer cannot control the temperature when the thermocouple is damaged. The maintenance method is to replace the galvanic couple, replace the temperature control meter (see the picture on the right), and replace the heating element.

5. If the speed is too fast, the inner layer of the coating has poor heat sealing performance. When the temperature is too low, the seal will leak or be unstable. The maintenance method is to slow down the speed, increase the temperature, and replace the material of the film.

6. The air pressure is wrong, the cylinder swing rod is loose, the heating temperature is low, and the heat seal is not good when the hot pressing roller and the transmission roller are not parallel. The maintenance method is to adjust the parallelism, adjust the temperature and air pressure to tighten it.

The above is what Xiaobian introduced to you, the faults and solutions that plasticine packaging machines may encounter. Of course, our company also produces many other automatic packaging machine equipment（China Tablet Packaging Machine Manufacturers）. If you have any other questions, please feel free to consult us!