Home > News > Solutions > Summarize common problems and solutions of pillow packaging machine
Certifications

Summarize common problems and solutions of pillow packaging machine

Summarize common problems and solutions of pillow packaging machine

JYT 2022-07-16 17:42:44

During the use of the machine, failures often occur. The main reason is that friction will occur between machine parts during operation, so if we want the machine to operate better, we must do maintenance first and troubleshoot in time. The following Jiayite packaging editor summarizes the common problems and solutions of pillow packaging machines.


China plasticine packing machine factory

Common faults and solutions of pillow packaging machines:

1. When the temperature is too high, the speed is too slow, and the heat resistance of the outer layer of the coating is poor, there will be traces of scorch wrinkles on the seal.
Solution: increase the speed, lower the temperature, and replace the film material.
2. The knife seat is too high or too low, the packaging speed is too fast, and when the push rod and the cutter are not synchronized, the cutter will cut on the product(China shisha packing machine manufacturer).
Solution: reduce the packaging speed, adjust the height of the end sealing parts, so that the center of the sealing knife is in the middle of the product height.

3. The color of the film color mark is too light, the film drive is slippery, and the cutting position will deviate from the color mark when the color mark tracking is not turned on.
Solution: refer to the packaging machine manual to adjust its sensitivity; in the man-machine dialogue interface, switch the tracking mode to "tracking cut".

4. The solid-state circuit breaker is burned out, the temperature control meter is damaged, and the thermometer cannot control the temperature when the thermocouple is damaged.
Maintenance methods: replace the galvanic couple, replace the temperature control meter, and replace the heating element.
5. If the speed is too fast, the inner layer of the coating has poor heat sealing performance. When the temperature is too low, the sealing will be leaked or not firm.
Maintenance method: slow down the speed, increase the temperature, and replace the material of the film. If the air pressure is wrong, the cylinder swing rod is loose, the heating temperature is low, and the heat-pressing roller and the transmission roller are not parallel, there will be poor heat sealing.